Overall Rating 3.912 out of 5 3.9 out of 5
27 of 34 (79%) customers would recommend this product to a friend.


27 of 34 (79%) customers would recommend this product to a friend.
Product Reviews
Overall: 4 out of 5 4 out of 5
Appearance: 5 out of 5 5 out of 5
Workmanship: 5 out of 5 5 out of 5
Value: 4 out of 5 4 out of 5
Product Experience:
Very Difficult 2 out of 5 Easy
Forgot
Location: Arizona
Age: Over 70
Gender: female
I have owned this product for: a day
Very nice looking Date: February 4, 2010
"We only ran into one problem while assembling.
We had to put niches in the bottom rear support board so that the unit could go over the plumbing pipes."
Share this Review: Facebook Digg DelIcioUs Twitter GoogleBookmark
Overall: 5 out of 5 5 out of 5
Appearance: 5 out of 5 5 out of 5
Workmanship: 5 out of 5 5 out of 5
Value: 5 out of 5 5 out of 5
Product Experience:
Very Difficult 5 out of 5 Easy
BClower

Very Satisfied with Purchase Date: January 28, 2010
"Directions for assembly are very clear and easy to follow. Good Quality and looks great!"
Share this Review: Facebook Digg DelIcioUs Twitter GoogleBookmark
Overall: 5 out of 5 5 out of 5
Appearance: 5 out of 5 5 out of 5
Workmanship: 5 out of 5 5 out of 5
Value: 5 out of 5 5 out of 5
Product Experience:
Very Difficult 3 out of 5 Easy
Chrissyb43
Location: Ontario, Canada
Age: 40-49
Gender: female
I have owned this product for: a week
Amazaing Quality Date: January 26, 2010
"Love the product but where are the screw covers?"
Share this Review: Facebook Digg DelIcioUs Twitter GoogleBookmark
Overall: 3 out of 5 3 out of 5
Appearance: 4 out of 5 4 out of 5
Workmanship: 3 out of 5 3 out of 5
Value: 3 out of 5 3 out of 5
Product Experience:
Very Difficult 3 out of 5 Easy
blooberry
Location: San Mateo, CA
Age: 40-49
Gender: female
I have owned this product for: a month
Just okay, but not many other choices out there Date: January 25, 2010
"Appearance: looks very nice, matches tilt-out hamper I also bought

Assembly: instructions very clear, except for putting on cabinet doors, which I still don't have on correctly -- they don't meet in the middle, and they sort of bend in to the magnet. I've tried 3 different ways with no luck. Also the bar at the bottom to hold it together is too low, so it hits the pipe coming in (lots of reviewers mentioned this). THE SOLUTION: don't cut the wooden bar -- just take out the two bottom screws and flip the board up, so it's still held together by two screws but it's out of the way. I left off the back board because I had already put the entire piece in place -- I don't think I could have lifted the entire piece into place otherwise.

Workmanship: it's shorter than I'd pictured, and even though it's hard wood (not particleboard) it felt lighter. The magnets are so tight that the whole thing jiggles when you try to open them. I haven't secured it into the wall yet, so that might help."
Share this Review: Facebook Digg DelIcioUs Twitter GoogleBookmark
1 2 3 4 5 ... 9 next >>